This product is Yokomos Drift Meeting & Yokomo Gumpur Approved Parts. In case
This product is an optional part exclusively for Yokomo YD-2.

��note
The completed photo below includes Yokomo YD - 2 kit body. YD - 2 conversion poison. several TN made Yokomo
Option parts are installed. Please purchase tires. foils. motors. batteries. mechanics required for traveling separately.

This product was developed by Kantos Rudlidi team INFINITY �� ROLL. It is a conversion made under the provision of its development data.
We have been developing for a long time on the premise of using hard carbon manufactured by USA. which is supplied only to grip type radio control makers.
We tested on all roads of asphalt. carpet. P tile and caracon for a long time. and we were able to obtain the performance required by INFINITY �� ROLL!
The machine they want. it is ... YD-2 is the best run! It is a high-performance. simple. and carbon-conformed car with aesthetics

��note
Battery holder is dedicated to battery holder for DRB. The normal battery holder included with the YD - 2 kit can not be used.
It is a separately purchased part made by Yokomo. Please prepare by yourself.
? DRB-118L DRB battery holder (for short lipo)
? Battery holder for DRB-118 DRB (for regular size lip)

It is a picture of the specifications mounted behind the battery. Poison can choose the place to install the battery from 2 places. The main chassis is 2.5 mm thick.


It is slender chassis design.
�� Note TN-303 side frame can not be installed.
�� Note TN-304 sub deck can not be installed.

It is a picture of the front mounting specification of the battery. Poison can choose the place to install the battery from 2 places.
�� Note The battery position shown below is for servo servo only.

This mechanical layout makes it possible to use the front tire. so the turnability improves. I think that it will be popular in 2018.
It is slender chassis design.
�� Note TN-303 side frame can not be installed.
�� Note TN-304 sub deck can not be installed.

The hole thinking that INFINITY �� ROLL is unnecessary is deleted. It is the specification that adheres to the aerodynamics of the back of the chassis! Inhibit the flow of air
It is a design with few holes. By the air flow effect. the grip seems to be high. The servo mounting hole can be selected from 3 locations.
For the rear suspensions. use objects of length 48 mm. (Included) In order to reduce the rear toe-in. the rear wheel base will grow too much
We are moving a lot of suspension arm movements. Although it is a concrete numerical value. we moved the RF suspension mount by about 3.0 mm to secure the travel distance.
3 mm thick Teflon spacer for extension is attached.

��note
Although the suspension pin for the rear is attached. the spare parts are Yokomos B4-009 B B-MAX III inner suspension arm pin
Please use ��3 X 48 millisus pin.

We made the width of the front and rear bulkhead and the width of the battery loader below 3 mm thinner. In order to prevent interference with the road surface. it is to improve the traction performance essential for the RWD machine. We also succeeded in earning the stroke of the suspension arm. Rebound can be set quite a lot