An aluminum rear hub carrier that can be used in common with the YD-2 series�� Using a universal shaft with a short axle shaft for narrow scrubs�� universal his joint pin position is set to the outside as much as possible�� and by bringing it closer to the outer suspension arm pin�� the suspension movement is activated and more direct movement is achieved�� It will be possible�� The conventional universal shaft can also be used by adding spacers�� so you can feel the difference in movement depending on the combination��
The feature of this rear hub carrier set is that the mounting position of the upper / lower arm can be selected�� and the length of the upper arm can be changed to variable by making the upper side a separate part�� controlling the change in the ground contact surface during rolling�� It is easy to use and is an effective setting point especially on road surfaces such as P tiles�� Since the mounting height of the lower arm can be selected from 4 positions�� the setting range of the roll center is greatly expanded�� and it is excellently compatible with weight adjustment around the rear��
* If you use the suspension arm mounting hole on the bottom side�� the suspension arm and the inside of the wheel may interfere depending on the type of wheel��